Kit d’intérieur 2 canaux 433 MHz 12v 5 telecommandes radio grille garage arrosage éclairage jardin
REF : R2CH12V5T
Emplacement : SUR COMMANDE
Security policy
Delivery policy
Terms of Sales
Indoor Kit 2 Channel 433MHz 12v 5 Remote Controls Radio Gate Garage Watering Garden Lighting
Wireless Remote Control Switch Receiver Quotes RF Technology Remote Garage Light Electric Door Switch DC 12V 10A 2CH 433MHz
Products can be used in homes, farms, factories, offices, laboratories, supermarkets, etc. Remote Control Garage Door \ Electric Door \ Home Door \ Shutter Door \ Expansion Door \ Gate Door \ Road Door
Remote Control Electric Curtain \ Water Pump \ Fan \ Lamp \ LED Light \ Bulb \ Ventilation Device \ Signal Transmission
Remote Control Motor Positive and Negative Rotation \ Motor Switch \ DIY
Relay Receiver Board Parameter
Working Voltage: DC 6V~30V
Input/Output: 1~250V
Quiescent Current: <5MA
Max Current: 10A
Max Load: 300W
RF Frequency: 433MHz
Working Temperature: -30~+80 Degree
Receiving Sensitivity: >97dbm
Storage Remote Control Quantity: 25pcs
Support Encoding: 1527 Leaning Code/2262 Fixed Code
RF Working Mode: ASK Superheterodyne Wireless Receiving
Receiving Range: Open Space Is Greater Than 50 Meters
Mode Remote Operation Mode: Momentary Mode/Toggle Mode/Latched Mode
Working Modes
You can set up 3 modes: Momentary Mode, Toggle Mode and Latched Mode.
Momentary Mode:
Press and hold button A, this relay will work; release button A, this relay will stop.
Toggle Mode:
Press button A, the relay will work; press button A again, this relay will stop.
Latched Mode:
Press button A, the relay will work; press button B again, this relay will stop, the second relay will work.
How to Set Up
Momentary Mode:
Press the learning button once, press A button once, succeed.
Toggle Mode:
Press the learning button twice, press button A once, succeed.
Locked Mode:
Press the learning button 3 times, press button A once, press button B once. Success.
Clean Data:
Press the learning button 8 times, the data will be cleaned. Not all remote controls can control this receiver.
If you want to change the mode, you need to clean the data first.