Control panel electronic alarm control panel with relais for keypad inoxtb, 2 channels control panels electronic alarm control p

Electrical Characteristics
Operating Voltage Range: 12/24V AC/DC
Input Current: Standby: 30mA; Maximum: 140mA
Outputs: 2 relays (Both relays: 10A)
Latch or Pulsed mode (01 to 99 seconds)
Visible Signals: Two free tension LEDs (Red & Green) and
Yellow LED
Audible Signal: One internal buzzer
Environmental Characteristics:
Operating Temperature: -15ºC to +50ºC
Operating Humidity: 0 to 95% (non-condensing)
Mechanical Characteristics:
Dimension (mm): 142 L x 108 W x 42 H
Weight (g): 210


Features

Simple to install ABS housing allowing easy mounting of the unit

2 output relays for 2-door operation

Recessed silicone membrane keypad for programming

Entire electronics can be removed from housing allowing ease in mounting and wiring

Internal buzzer and Yellow LED for programming and status indication

Codes and operating parameter are stored in non-volatile EEPROM

99-user codes memory

Free of potential LEDs (Red and Green)

Integrated CODIX bus for easy connection of peripherals (keypad / proximity reader)

2 pushbutton inputs; both can act independently with any of the output relays
Networkable user-friendly control unit for high security applications

VI200 is an easy-to-use practical control unit for a wide variety of applications in the domains of alarms, access control and automation. VI200 offers an increased security level over standard digital Keypads as it is to be installed in a secure area with the peripherals being installed in the unsafe areas. VI200 has to be networked with up to 3 peripheral units over the 3-wire CODIX bus.

VI200-R version includes radio receiver technology in addition to the features of VI200.

Features

: Programmable Control Unit
: Recessed silicone membrane keypad
: All electronics contained inside the housing
: User memory of up to 99 codes
: Simple to install ABS housing allows easy mounting of the unit
: Requires minimal maintenance
: Easy to access connector terminals for ease in installation
: Dust proof and water-resistant
: Two 10 Amp relay outputs and 2 pushbutton inputs allows control over two doors
: Programming of the peripherals is done using the integrated keypad of the VI200
: Access is gained through the connected peripherals
: For door control, the relays gets activated from the VI200 itself ensuring maximum security
: Incorporates power switching regulator type L4960 for high efficiency conversion of 24/12V into system voltage (normal regulator dissipates excess power as heat that shortens the product life)
: Up to 3 peripherals (keypad e.g. INOX / proximity reader e.g. MINI) can be connected over the CODIX communication bus
: 2 free tension LEDs (Red & Green) provide remote information (door position, door status…)
: Disables after 8 incorrect consecutive attempts and beeps for 30 seconds
: Programming and Output status with Buzzer and LED indication
: EEPROM stores data, unaffected by power failure
: VI200-R with integrated radio receiver works with radio transmitter type TX2